Prepared by
S.Santhosh (Admin)
Important questions
share it a link alone
Don't waste my hardwork and valuable time
Don't share as screenshot kind request
most viewed dept will get update at first So Dont screenshot
Unit-11.memrory organization **
2.Addressing modes
3.intrept programming Unit-21.ARM general Instruction set**2.DSP on ARM
3.Basic programming**
Unit:3
1. ADC/DAC Interfacing **
2. Architecture of ADCARM: I/O Memory3.UARTSerial Communication with PC
4. Stepper motor interfacing***UNIt 41.ARM with CAN2. I2C
Unit-51.Raspberry Pi Architecture ***3.Working with RPi using Python and Sensing Data using Python-programming***
2. GPIO and Interfacing Peripherals with Raspberry Pi
Don't share as screenshot -Stuff sector
**Very important questions are bolded and may be asked based on this topic
PART-C
1.Compulsory Questions {a case study where the student will have to read and analyse the subject }mostly asked from unit 2, 5(OR) a situation given and you have to answer on your own
2.Addressing modes
3.intrept programming
2.DSP on ARM
3.Basic programming**
1. ADC/DAC Interfacing **
2. Architecture of ADC
3.Working with RPi using Python and Sensing Data using Python-programming***
2. GPIO and Interfacing Peripherals with Raspberry Pi
Don't share as screenshot -Stuff sector
**Very important questions are bolded and may be asked based on this topic
don't waste my hardwork and valuable time
Contact uS for more updates
*These questions are expected for the exams This may or may not be asked for exams All the best.... from admin Santhosh
Thanks for your love and support guys keep supporting and share let the Engineers know about Us and leave a comment below for better improvements If there is any doubt feel free to ask me I will clear if I can or-else I will say some solutions ..get me through WhatsApp for instant updates ~$tuff$£ctor
SYllabuS
UNIT I – ARM ARCHITECTURE
-Architecture
-Memory Organization – addressing modes
-Registers
-Pipeline
-Interrupts
-Coprocessors
-Interrupt Structure
UNIT II – ARM MICROCONTROLLER PROGRAMMING
-ARM general Instruction set
-Thumb instruction set
-Introduction to DSP on ARM
-Basic programming
UNIT III – PERIPHERALS OF ARM
-ARM: I/O Memory
-EEPROM
-I/O Ports
-SRAM
-Timer
-UART
-Serial Communication with PC
-ADC/DAC Interfacing
-Stepper motor interfacing
UNIT IV – ARM COMMUNICATION
-ARM with CAN, I2C, and SPI protocols
UNIT V – INTRODUCTION TO SINGLE BOARD EMBEDDED PROCESSOR
-Raspberry Pi Architecture
-Booting Up RPi
-Operating System and Linux Commands
-Working with RPi using Python and Sensing Data using Python-programming
-GPIO and Interfacing Peripherals with Raspberry Pi